RHEINTACHO Messtechnik GmbH | Measurement, control and indication of rotational speed

RT STROBE control – For the right solution in every situation and immaculate image clarity

RT STROBE control is your easy-to-handle control centre for any stroboscope, whether it is from Rheintacho or another manufacturer. Use it to create a trigger signal or to influence a signal generated externally. The multiplicity of control parameters make it easy for you to carry out the inspection or measurement tasks required of you. See a selection of typical cases below*:

• Task: The trigger signal is generated before the required observation point. Result: The stroboscope flashes too early.
  
  Solution: Set a time delay between the input and output signals in ms steps until the stroboscope delivers the required view.
  
  
• Task: Your equipment is consistently transmitting the trigger signal before location to be observed. However, your equipment runs at different speeds. Result: Your stroboscope flashes at different locations, some of which are unusable.
  
  Solution: Use phase shift (in degrees) to permanently shift the flash position. The stroboscope will now adapt automatically to changing speeds and will flash at a location which is shifted by the set angle.
  
  
• Task: An external trigger (e.g. a sensor) is monitoring a gear-wheel. Its frequency is many times greater than the required flash frequency. Result: You don't receive the required control image.
  
  Solution: Instead of using each input signal, the impulse divider only triggers a flash impulse after every 10th, 25th or 255th input signal. Set the value in key steps or in "continous flow" mode until the required result is displayed.
  
  
• Task: You need measurement values to be displayed in a variety of formats.
  
  Solution: You have the following options: the instrument can display FPM, rpm or Hz.

Scope of delivery:

• Stroboscope control unit RT STROBE control
• Operating instructions
• Trigger cable 1,5 m
• Certificate
• Case

Accessories (optional):

• Power supply unit
• Mounting device
• Extension cable for trigger connection
• Adapter for stroboscopes of other manufacturers and Rheintacho stroboscopes of different construction types

Technische Änderungen vorbehalten.

Technical data subject to change without notice: